Passive Infra Red sensor signal conditioning IC JHM5001

JHM5001 is a signal conditioning IC for passive infra red (PIR) sensor. The PIR sensor gets the changing infrared signal to JHM5001 so as to amplify and make the weak signal to be big enough for the sensor system.

JHM5001 is a signal conditioning IC for passive infra red (PIR) sensor.The PIR sensor can sense the changing infrared signal. JHM5001 works to amplify the weak signal generated by the PIR sensor, convert the ADC in the IC into a 16 bit digital signal. After the digital filter processing, the algorithm unit judges whether the change of the PIR signal is caused by the movement of the external human body, and outputs the digital signal through the rel pin.The sensitivity and delay parameters of PIR sensor can be set by applying voltage to sens and ontime pins respectively. The voltage will be converted into 7-bit digital signal by internal ADC.




  • Based on digital signal processing

  • Integrated on chip voltage regulator, suitable for 2.5V ~ 5.5V supply voltage

  • Low power consumption, current ~ 30uA 

  • Insensitive to RF interference

  • Input pin with adjustable sensitivity and on time

  • With light detection input pin, can prevent white light interference

  • With switch or relay control output pin and LED control output pin

  • Short stable time after power on

  • Available in DFN8 and SOP8



Minimum circuit schematic for LED indication with intelligent PIR sensor.